manualshive.com logo in svg

DV8 SRBR-01, Installation Manual, Page: 3 / 4

Share
Download
DV8 SRBR-01 Installation Manual Download Page 3

INSTALLATION 

MANUAL

855-680-9595

NEED HELP?

STEP

 4

Remove the two outside bolts on 
the rear body mount using a 15mm 
socket. 

STEP

 5

 

With additional help, hold the slider 
up to the body mounts so that slider 
is positioned over the studs. (Large 
mount on slider will be used on 
the rear mount) Using the factory 
hardware tighten the nuts to 50ft lbs. 

Note: You will need to use at minimum a 
10” extension to reach to the nuts on the 
rear mount. 

Summary of Contents for SRBR-01

Page 1: ...ble for any bodily injury or harm to you or your vehicle as a result of an improper install Proper installation of this kit required knowledge of the factory recommended procedures for removal and installation of original equipment components We recommend that the factory shop manual and any special tools needed to service your vehicle be on hand during the installation Installation of this kit wi...

Page 2: ...o bolts just outside of the main body mount bolt When bolt bolts are removed and small metal plate will become free Remove this plate and set off to the side since it will not be reused STEP 2 Remove any factory sliders steps or rock rails if equipped since they cannot be used with our sliders Broncos with factory equipped rock sliders will have brackets for mounting on the underside of the vehicl...

Page 3: ...socket STEP 5 With additional help hold the slider up to the body mounts so that slider is positioned over the studs Large mount on slider will be used on the rear mount Using the factory hardware tighten the nuts to 50ft lbs Note You will need to use at minimum a 10 extension to reach to the nuts on the rear mount ...

Page 4: ...INSTALLATION MANUAL 855 680 9595 NEED HELP STEP 6 Double check all hardware is secure and the sliders are tight ...

Reviews:

No comments