© DV Signage 2012
Page 7 of 14
3.2 Configure a NETCFG.INI for slave unit
Copy all video content on to “media” folder on USB flash drive.
Create a NETCFG.INI and place it in the “media” folder on the USB flash drive.
Update the video content and NETCFG.INI on to the Slave unit (VS-700) through
USB update
. (see VS-700 user guide)
The NETCFG.INI file contains some system and network settings. The following table
shows the major options required in Video synchronization.
Options in NETCFG.INI
Description
IP_OVERWRITE
0 – Keep old IP address
1 – Use the new IP address
IP
IP address
NETMASK
Subnet Mask Address
GATEWAY
Gateway address
DNS1
DNS1 address
DNS2
DNS2 address
NETSYNC_SLAVE_MODE
Slave mode enable
(0=disable, 1=enable)
NETSYNC_MASTER_ADDR
An IP address of Master unit
Below is an example of a NETCFG.INI file for “Slave unit”:
IP_OVERWRITE=1
IP=10.1.0.71
NETMASK=255.255.255.0
GATEWAY=10.1.0.1
NETSYNC_SLAVE_MODE=1
NETSYNC_MASTER_ADDR=10.1.0.70
Note: All master and slave unit must in different static IP addresses.
Both master and slave unit must contain the same content (but different in playlist
settings – see Section 4).
