Installer’s Guide – Endurance six
™
6
Part No: IG090701
Version: B
Step 8
• This unit has a preset temperature of
50°C.
• If controllers are installed, the
maximum temperature setting will
still be 50°C.
Step 9
• Make sure there is water inside the
unit prior to turning on the power.
This can be achieved by turning on
the tap.
Step 10
• If the water heater has been installed
correctly, when the power is turned
on the heater will go through
initialisation. This will take a few
seconds.
• If a fault occurs, please refer to the
Owner’s Manual
.
• The gas valve must be checked for
gas pressure during operation.
• The test point pressure should be
set in accordance with the pressure
rating marked on the data plate label,
located on the side of the heater.
• Commission appliance and check
safe and correct operation of the
appliance.
