8
6. MelODy selectION
The radio gongs melody selection takes place via the transmitter (Fig. 5).
Slide switch
: K – for 3-sound-tone, K2 – for Westminster-melody, K3 – for polyphone melody
Slide switch
: „SEQ“ - for alternating melody at K3;
„SET“ – to use a selected melody at K3
If slide switch
is at K3 then the gong plays a defined polyphone melody or alternating polyphone melodies.
Pushing the slide switch
to „SEQ“ enables you to select the desired polyphone melody by pressing the transmitter. To ensure that
the gong only plays this selected melody the slide switch must be pushed to the „SET“ position without having pressed any other but-
tons in the meantime. If the slide switch remains in the „SEQ“ position any random polyphone melody is played.
Note: On changing the battery or changing a module respectively the melody is automatically reset to a standard melody and must
be reset if necessary.
7. selectING the Bell MODe
If the sliding switch
C
is in the A position the gong plays the selected melody when the transmitter is actuated and activates a vibration
alarm at the same time. If the sliding switch
C
is in the A2 position, only the vibration alarm is activated. If the sliding switch
C
is in
position A3, only the set melody sounds when the transmitter is actuated.
8. ADjustING the VOluMe
Four different volumes can be selected in stages by pressing the „VOL“ button () in the gong.
Note: On changing the batteries or changing a module respectively the volume is automatically reset to „LOUD “ and must be adjusted
if required.
9. OperAtION WIth sOuND MODule
By using the sound module (not included) additional polyphone melodies or sounds can be played when in the „T3“/„K3“ mode. Insert
the sound module into the expansion slot (Fig. 3) and carry out the melody selection as explained in point 6.
10. OperAtION WIth usB-MODule
By using a USB-module (not included) your own choice of polyphone melodies (midi/wave) can be played in „T3“/„K3“ mode.
Install the USB software from the düwi homepage (www.duewi.com). Insert the USB-module with download function into the USB hub of
your computer and use the software to load the desired music file from your computer onto the USB-module. Insert the USB-module into
the expansion slot (Fig. 4) and carry out the melody selection as explained in point 6.
Characteristics
• USB Version . /2.0
• Compatible with Windows 2000 and Windows XP
• 28 Kbytes storage
• Saves up to 64 melodies
• Supports MIDI (.mid) and WAVE (.wav) file formats
• Supports general MIDI (.mid) and all music and percussion instruments
• Supports MIDI 0 and MIDI format (most commonly used for mobile phone ring tones)
GB
