Cooling mode
When the device is not filled with water it can be used as a FAN.
When using the device with the water tank filled with cold water, the cold water will be
circulated, generating a cool breeze.
Filling the water tank:
• Switch off the device and disconnect it from the mains power supply.
• Open the water filling reservoir cover
2
• Pour clean fresh cold water in the reservoir (max 250ml).
Preferably use distilled water to avoid scalding.
• After the water has been fully soaked by the honeycomb
filter
3
, the water level indicator
7
drops to low.
• Then fill another 250 ml of clean fresh and cold water.
• Observe the water tank level indicator
7
and do not
overfill the tank.
• Close the water filling reservoir cover
2
• Do not move or tilt the device while operating, to avoid water spilling.
Note!
• ONLY USE CLEAN FRESH WATER, AND DO NOT ADD ANY ADDITIVES!
• DO NOT USE WATER ABOVE 40°C
Vaporizing mode
Press the power ON/OFF button
1
on the device to enable the
continuous
vaporizing
function, the corresponding LED
3
lights up.
Press the power ON/OFF button
1
on the device again to enable the
interval
vaporizing
function, the corresponding LED
3
starts to blink. In this mode the evaporation will be in a
pattern of 4 seconds on, 1.5 seconds off.
Note!
Let the honeycomb absorb the water (±3 min), before enabling the vaporizing
function.
Press the power ON/OFF button
1
on the device again to switch off the vaporizing
function, the corresponding LED
3
will switch off
Emptying the water tank:
• Switch off the device and disconnect it from the mains power supply.
• Remove the drain plug
10
on the bottom in the device.
• Drain the water from the water tank.
• Place the drain plug
10
back on the bottom in the device.
Note!
Make sure all water is drained after each use.
4) CLEANING AND MAINTENANCE
Warning
Before cleaning the device, always switch it OFF, disconnect it from the mains electricity
supply.
EN 06
