Dustbane Power Clean 1200 XT, Parts & Operation Manual

Page: 6 / 28

6
ENGLISH
Rinse Out Recovery Tank
Build-up of fine silt and debris can damage the auto-dump pump and dump valve. Clean out the recovery tank on a regular basis to
extend the life of these components as well as keep the tank and machine smelling better.
To rinse out recovery tank, remove the recovery tank lid and open the dump valve. Place a bucket under the dump valve. Use a hose
to rinse the dirt and debris out of the recovery tank. Close the dump valve and spray the tank with deodorizer or disinfectant.
Proceed to waste pump cleaning and replace the recovery tank lid. Dispose of dirty water and debris.
Clean Pump Inlet Filter
CAUTION: before proceeding with this procedure, make sure both the power cords are disconnected.
Solution tank
Latch
Base
• To examine the filter, open the solution tank lid on the front of the
machine. The filter is in the bottom of the solution tank.
• Grasp the filter cap and unscrew the filter from the brass nipple by
turning counter-clockwise. Clean or replace the filter as needed.
• Tilt the tanks back onto the base and secure the latch.
1/4” Acorn Strainer
Part No. 10-0845
WD-40 Vacuum Motors
Should moisture ever enter the vacuum motors, completely drain the recovery tank, open the recovery tank lid, remove the vacuum
float assembly, turn on both vacuum motors and spray a five (5) second burst of WD-40 into the standpipe. Continue to run the
vacuum motors for at least three (3) minutes.
To prevent moisture from damaging the vacuum motors during storage, empty the recovery tank and store with the lid open.