10
Brush attachment:
turn the machine on by pressing the main switch (ref. 3) (LED on), then press the brush
button (ref. 4 (LED on). Rest the brush on the floor in front of the machine. Raise the front of the machine by
levering on the handle, then lower it onto the brush, centering it with the brush cover. Operate the brush lever
repeatedly until the brush automatically engages on the flange hub. If the maneuver is not successful, press on
the handle again and repeat the centering and repeated operation of the brush lever.
Brush release:
turn the machine on by pressing the main switch (ref. 3) (LED on), then press the brush button
(ref. 4 (LED on). Raise the front of the machine by levering on the handle, then operate the brush lever repeatedly.
After a few pulses, the brush (or drive disk) is released and falls to the ground.
6.5. Detergents - Instructions
Important
Always dilute the detergent according to the manufacturer’s instructions. Do not use sodium
hypochlorite (bleach) or other oxidants, particularly in strong concentrations. Do not use solvents
or hydrocarbons. The temperature of the water and detergent must not exceed the maximum
indicated in the technical specification. They must be free of sand and/or other impurities.
The machine has been designed for use with low-foam biodegradable detergents made specifically
for scrubber dryers.
For a complete and up-to-date list of the detergents and chemicals available, contact the Manufacturer.
Use products suitable for the floor and dirt to be removed only.
Follow the safety regulations on use of detergents given in the section “Safety regulations”.
6.6. Preparing the machine for work
Important
Before starting work, wear overalls, ear protectors, non-slip waterproof shoes, mask to
protect the respiratory tract, gloves and all other personal protection devices recommended
by the supplier of the detergent used or necessitated by the work environment.
Before starting work, proceed as follows:
1. check the battery charge (charge if necessary);
2. make sure the recovery tank is empty. If necessary, empty it;
3. via the opening at the front, fill the solution tank with a suitable concentration of clean water and low-
foam detergent. Leave at least 5 cm between the surface of the liquid and the opening of the tank;
4. mount the most suitable brushes or drive disks for the floor and work to be performed;
5. make sure the squeegee is firmly attached and connected to the suction hose. Make sure the back
blade is not worn.
Summary of Contents for 19352-C-AGM
Page 2: ......
