Sharp Edge Hazard.
Be careful of sharp edges on device and
HVAC equipment while installing the device.
Personal injury may result.
INSTALLING THE LAMP
(Fig.3)
To maximize the efficiency and life of the UV-C
lamp, clean each lamp prior to installation.
Use isopropyl alcohol and cotton cloth to wipe
dust and fingerprints from the lamp.
Gently insert the lamp into the lamp hole.
Slide the bracket over the the retaining lip of
the lamp and tighten the two knurled nuts until
the lamp is securely fastened. The lamp seals
against the base of the unit using a rubber
grommet which prevents air leaks. Repeat for
each lamp of the installation.
Fig. 3
Lamp is secured with a sliding bracket tightened with two
knurled nuts.
Fig. 4
Reinstall lamp housing.
REMOTE LAMP HOUSING
(Fig.4 )
After lamp has been installed, reinstall the
remote lamp housing using the knurled nuts.
The remote lamp housing must be in place
prior to attaching the electrical harness.
Clean lamp(s) prior to installation.
Failure to remove dirt and fingerprints from
the lamp(s) could shorten their lifespan.
CAUTION
UV-C Light Hazard.
UV-C light can cause temporary or permanent loss of
vision, and sunburn. Take precautions to protect eyes
and skin from direct exposure.
WARNING
BIO-FIGHTER® VERSALIGHT 1S, 2S INSTALLATION & OPERATION MANUAL
4
CAUTION
Fig. 2
Lamp is secured with a sliding bracket tightened with two
knurled nuts.
REMOTE LAMP MOUNTING
(Fig.2)
Remove the remote lamp housing from the
remote lamp base by removing the knurled
nuts. Then install the remote lamp base to the
surface with the includes mounting screws.
Using the remote lamp base as a template,
drill a 1" hole for the lamp. Repeat for the sec-
ond lamp base if applicable.
