Duronic MG1600, Manual

Page: 5 / 28

8 9
- Check that voltage indicated on the rating label corresponds to the mains
voltage in your home.
- Wash all parts (except body) with warm soapy water.
Assembling
- While holding the head, inset it into the inlet
(fig.1). Rotate the head in the same direction as
fig.2 until a click can be heard. Move the head
slightly to ensure it is placed in securely.
- Place the feed screw into the head (long end
first) by turning the feed screw until it is set into
the motor housing (fig.3).
- Place the cutting blade onto the feed screw
shaft with the blade facing the front as
illustrated (fig.4). If it is not fitted properly, meat
will not be ground.
- Place the desired cutting plate next to the
cutting blade, fitting protrusions in the slots
(fig.5).
- Support or press the centre of the cutting plate with one finger then screw
the fixing ring until tight with the other hand (fig.6). Do not over tighten.
- Place the hopper plate on the head and fix into position.
- Place the unit on a flat, non slip surface.
- The air passage at the bottom and the side of the motor housing should be
kept free and not blocked.
First Time Use
Instructions for Use
Cleaning and Maintenance
Mincing Meat
- Cut all food into pieces (boneless and fatless meat is recommended, approx
20mm x 20mm x 60mm) so that they fit easily into the hopper opening.
- Plug in and
press the ON/OFF button to turn on the machine.
- Feed food into the hopper plate. Only use the food pusher (fig.7)
- After use, switch the unit off and unplug it from the power supply.
Reverse Function
- In case of jamming, switch the appliance off by
pressing
the ‘ON/
OFF
’
button and press the "REV" button.
- Feed screw will rotate in the opposite direction and the head will become
empty.
- If it doesn’t work, switch the unit off and clean it.
Disassembling
- Make sure that the motor has stopped completely.
- Disconnect the plug from the power outlet.
- Disassemble by reversing the steps from images 6-1.
- If the fixing ring is not easily removed by hand, please use tools in fig 12.
- To remove the cutting plate easily, place a screwdriver between the cutting
plate and the head as illustrated and lift it up (fig.13).
- Press the unlock button before removing the head. Holding the head, rotate
it in the same direction as fig. 14. The head can then be removed easily.