Duronic GHS48, Manual

Page: 11 / 68

11
NORMAL CYCLE: 14 hours on / 10 hours
off
Press this button and the system will be
switched on. It will sound a “beep” and run in
‘normal cycle’ mode. This means the LED light
panel will light up for 14 hours. It will then switch off for 10 hours. The
following day it will repeat this pattern: 14hrs on / 10hrs off.
Power button
Press this button it will sound a “beep” and
the system will be switched on into ‘standby
mode’.
SHORT CYCLE: 12 hours on / 12 hours off
If you press this button, the system will sound a “beep” and enter the
‘short cycle’ mode. The LED panel on the top will reduce the intensity of
the light and will start a cycle of 12 hours on / 12 hours off.
LONG CYCLE: 16 hours on / 8 hours off
If you press this button, the system will sound a “beep” and enter ‘long
cycle’ mode. The LED panel on the top will increase the intensity of the
light and will start a cycle of 16 hours on / 8 hours off.
Using the Control Panel
24 Hour Light-On Setting
If you wish to keep the light working all day long (for a whole 24 hours), hold
the power button down for 3 seconds.
The light will blink 3 times, then the whole system and lights will switch on
and stay on for 24 hours. After this time elapses, the system will automatically
revert back to ‘standby mode’.
If you activate this 24-hour light mode while the lamp is currently working, it will
keep the lamp lit constantly until the end of the programmed cycle and then
revert back to the mode you had been using previously.
12h
16 h
1 4 h
12h
14h
16h