DURKOPP ADLER DAC eco M-Type, Instructions For Use Manual

Page: 11 / 40

Safety
Instructions for use DAC eco M-Type - 01.0 - 10/2015 9
3 Safety
This chapter contains basic information for your safety. Read the
instructions carefully before setting up or operating the controller.
Make sure to follow the information included in this chapter. Failure
to do so can result in serious injury and damage to the machine.
3.1 Basic safety instructions
The DAC eco M-Type controller may only be used as described
in these instructions.
The instructions should be available at the controller's location at
all times.
Work on live components is prohibited.
The controller was built and tested in compliance with all valid
ordinance and safety regulations, and left the factory in proper
working order.
The controller will only work safely and reliably when it is used as
intended (

4.3 Proper use , S. 15).
Before leaving the workplace:
• Switch off the controller
• Wait until the machine stops
• Wait until the LEDs go out
Obligations
of the operator
Observe the country-specific safety and accident prevention reg-
ulations and the legal regulations concerning industrial safety and
the protection of the environment.
All warnings and safety signs on the controller must always be in
legible condition and may not be removed. Missing or damaged
labels should be replaced immediately.
Requirements to
be met by the
personnel
The controller may only be set up by qualified technicians. Qual-
ified technicians are personnel with electronics and mechanical
training.