DURKOPP ADLER 550-532, Instruction Manual

Page: 62 / 94

Settings via software (sewing automat)
Instruction manual 550-532 - 00.0 - 07/2015 60
6. Use the +/- Program keys to select the next stitch.
7. Repeat steps 3 to 5 for all further stitches.
8. Press the
Ready key to save the edited seam pattern.
9. Press the Reset key.
 The key LED goes out.
10. Press the USB key.
 The key LED goes out.
7.20 Error messages
If an error occurs, the Error symbol LED illuminates.
Error message Description Possible cause Remedy
E 8 Error
Table data
Table data could not be read • Save the table data
anew.
E 1 0 Error
Seam pattern
number
The selected seam pattern is
not stored in ROM or has
been disabled. Seam pattern
"0" • Press the Reset key to
confirm the seam pat-
tern number.
E 3 0 Error
Upper needle
bar position
Needle bar is not in the
upper position • Check the connections.
• Rotate the needle bar to
the top dead center.
E 4 0 Error
Needle field
area
Needle field area exceeded • Press the Reset key.
• Check the X/Y scaling.
E 4 2 Error
Enlargement
Sewing length is more than
10 mm • Press the Reset key.
• Check the seam pattern
and the X/Y scaling.
E 4 5 Error
Seam pattern
data
Seam pattern data could not
be accepted • Press the Reset key.
• Check the ROM.
E 5 0 Pause Reset key pressed while
sewing.
Sewing automat stopped. • Press the Reset key.
• Trigger the thread cutter.
• Start the sewing process
anew.
E 3 0 2 Error
Machine head
Machine head is tilted over. • Tilt the machine head
back into place.