Adjusting the winder
34
Service Instructions 512-211-01/532-211-01 - 00.0 - 06/2016
10 Adjusting the winder
10.1 Setting the fill volume
Correct setting
1.
Wind onto an empty bobbin (
Operating manual, Section 4.4
).
Winding stops automatically when the bobbin is filled to approx.
0.5 mm below the bobbin edge.
Fig. 25: Setting the winder fill volume
Adjusting steps
Rough adjustment
1.
Loosen the clamping screw (2).
2.
Align the actuating lever (4):
•
Smaller fill quantity:
Push towards bobbin.
•
Larger fill quantity:
Push away from bobbin.
3.
Tighten the clamping screw (2).
Fine adjustment
4.
Loosen the adjusting screw (1).
NOTICE
Property damage may occou!
When operated without sewing material the sewing feet and bobbin
case in the hook can be damaged.
Enable the winding mode (
Operating manual, Section 5.8
Winding
) and remove the bobbin case from the hook to perform a
test winding process.
(1)
- Adjusting screw
(2)
- Clamping screw
(3)
- Thread guide plate
(4)
- Actuating lever
1
2
3
4
Summary of Contents for 512-211-01
