DURAVIT Blue Moon Combi-System L 760143000CL1000, Operating Instructions Manual

Page: 36 / 260

36
8. Maintenance
Residual-current circuit-breaker
Check the residual current circuit breaker (RCD) regularly as described in its operating
instructions.
9. Troubleshooting support
CAUTION
The whirltub may be repaired only by a qualified plumber and electrician.
Problem Potential cause Solution
Foaming Soap or shampoo in the bath-
water.
>
Switch off the whirl system.
>
Fill the tub with fresh water.
Whirl system does not start? Water level too low.
>
Add water until the water
level is about 5 cm above the
uppermost jet.
Mains switch is switched off.
>
Switch on at the mains.
Mains fuse is switched off.
>
Switch on the mains circuit
breaker.
Ground-fault switch (RCD) or
circuit breaker has tripped.
>
Disconnect the tub from the
mains.
>
Call customer service.
Control panel does not
respond?
System error
>
Disconnect the tub from the
mains.
>
Start up the tub again.
After the water is drained,
the air jets start automat-
ically and the "Air jets"
button flashes.
The floor jets blower automat-
ically starts a 2-minute drying
mode to remove any remaining
water from the pipes.
Sound of motor during fill-
ing / after draining the tub.
Residual water drain pipes and
actuators are open / closed.
There are 4 short signal
tones when activating the
air-water or water massage.
UV hygiene management is
defective.
>
Call customer service.
>
Report the number of signal
tones.