12
Rear Shock Tower, Rear Transmission Plate,
Rear Bulkhead, Rear Suspension Arm
1. Attach the rear chassis plate (41) to the chassis (1) using four
3x10mm round head screws (C).
2. Attach the rear suspension arms (36,37) to the rear chassis
plate using the inner rear hinge pins (97).
3. Secure the front of the inner rear hinge pins in place using two
2.5mm e-clips (S).
4. Install the rear body mount posts (129) into the body mount
bracket (57). Secure each post using a 3x6mm pan head screw
(J). Secure the complete body mount assembly to the rear
shock tower (40) using two 3x10mm round head screws (C).
5. Install the rear shock tower (40) and transmission brace (42)
onto the chassis using four 3x12mm round head screws (D).
Note: Make sure the screws pass through the shock tower,
chassis and into the transmission brace.
6. Install two long ball studs (30) into the appropriate holes in the
transmission brace.
Note: The stock setting is the lower inner
holes. Make sure that the ball studs are in the same hole
location on both sides.
40
42
C
C
41
S
S
37
36
97
97
30
U
U
129
129
57
J
J
30
1
C
D
108
108
58
58
S
S
107
9
79
22
36
37
128
81
26
58
58
S
S
107
108
108
9
22
79
128
81
27
Rear Hub, Rear Axles
1. Install two 5x10mm bearings (108) in both of the rear hubs (26,27).
2. Install a short ball stud (81) into the center hole on the front of the
rear hubs.
3. Place one 3mm plastic spacer (58) on each side of the rear hubs.
Secure the rear hubs to the rear suspension arms (36,37) with the
3mm outer rear hinge pins (107).
4. Secure the outer rear hinge pins with 2.5mm e-clips (S).
5. Install the rear axles (9) through the bearings in the hubs.
6. Install a rear axle pin (128) into each of the rear axles.
7. Install one joint spring (22) into each of the axles.
8. Install a dogbone (79) into each of the axles.
MAINTENANCE
