11
Steering Servo Saver Assembly
1.
Insert the short servo saver post (99) into the right brass bushing (105) in the chassis.
2.
Install two short ball studs (81) into the right servo saver (46) in the holes shown.
3.
Insert a plastic bushing (48) into each end of the right servo saver. Again, make sure the
bushings are fully seated.
4.
Slide the assembled right half onto the short servo saver post (99).
5.
Install two short ball studs (81) into the lower left servo saver (44) in the holes shown.
6.
Insert the threaded aluminum servo saver hub (101) into the bottom of the lower left
servo saver.
Note: The aluminum servo saver hub is designed to key into the
bottom of the lower left servo saver. Make sure that the hex in the hub fully seats
in the servo saver.
7.
Install a ball stud (81) into the upper left servo saver (45).
8.
Slide the upper left servo saver onto the hub. The upper and lower left servo savers are
designed to key together.
9.
Place the servo saver spring (98) on top of the two left servo savers.
10. Secure the left servo saver assembly together with the servo saver adjustment collar
(102).
Note: The servo saver adjustment collar is machined on one side for the
servo saver spring to fi t into. Make sure this side faces down against the servo
saver spring. The servo saver spring will need to be properly adjusted once the
entire servo saver assembly has been installed on to the Evader EXT2.
11. Insert a plastic bushing (47) into each end of the left servo saver assembly. Again, make
sure the bushings are fully seated.
12. Install the long servo saver post (100) into the left brass bushing (105) in the chassis.
13. Slide the assembled left servo saver assembly onto the servo saver post.
14. Attach the left and right servo savers together with the one-piece
molded link (43).
105
105
100
47
48
48
47
102
81
81
81
81
81
43
99
46
101
98
45
44
Servo, Servo Brace, Front Brace
1. Attach the steering servo mounts (6) to the front of the
servo mounting lugs using two 3x8mm S/T screws (L).
2. Install a short ball stud (81) into the steering servo horn (8).
3. Install the steering servo horn onto the servo with a
2.6x8mm S/T screw (T).
Note: Make sure the transmitter,
steering servo and servo horn are properly centered
before securing the servo horn to the servo.
4. Secure the servo to the chassis with two 4-40x5/16" fl at
head screws (B).
5. Attach the servo brace (56) to the chassis by installing two
3x10mm screws (C) into the two rear holes.
6. Connect the servo horn to the servo saver assembly using
the adjustable steering servo link (5,90).
7. Install two brass bushings (105) into the underside of
the front brace (52).
Note: The bushings must be fully
seated into the front brace. This may require lightly
tapping the bushings into place.
8. Install the front brace onto the servo brace and servo saver
assembly. Make sure the servo saver posts insert into the
bushings in the front brace. Secure the front brace with four
3x20mm screws (E) into the chassis and two 4-40x5/16" fl at
head screws (B) into the bulkhead.
C
C
E
E
E
E
B
B
B
B
52
105
105
8
81
T
6
6
5
5
90
Servo Saver
Posts
Servo
56
L
L
