4
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF ELECTRICAL &
ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste
Electrical & Electronics Equipment (WEEE). Any WEEE marked products must
not be mixed with general household waste, but kept separate for the treatment,
recovery and recycling of the materials used. Contact your local authority for details
of recycling schemes in your area.
Made in China. PR2 9PP
Man Rev 1.0
SPECIFICATIONS
Power Consumption
48W
Input Voltage
220-240V~50Hz
Output Voltage
24V AC
Temperature Range
150-450°C
Temperature Accuracy
+/-5°C
Weight
2kg
•
“ERROR” is displayed -
A loose connection - check
connection of the iron to the station.
•
Tip will not reach set temperature - Defective heating element
•
Solder will not wet the tip -
Tip temperature is too high.
Tip is badly oxidized and requires cleaning.
TROUBLESHOOTING
CLEANING
•
Cleaning should only be done when the iron is switched off and at room
temperature.
•
The iron may be cleaned with a damp cloth and a small amount of liquid detergent
if necessary.
•
Never submerse the soldering iron in liquid or allow any liquid to enter the case.
•
Do not use any chemicals, abrasives or solvents that could damage the soldering
iron.
Caution
: Damage could occur if the iron is left on without the tip inserted.
•
After removing the tip, blow out any remaining oxide dust that may have formed in
the tip retaining area of the barrel.
Warning
: Care should be taken to avoid getting dust in your eyes.
•
Replace the tip and tighten the knurled nut barrel assembly with your fingers.
•
Pliers should only be used to tighten the nut if loosening occurs when the iron is
hot.
•
Do not over tighten the nut as the element could be damaged.
