Duratool D03405 Manual Download Page 8

Comfort Level 

Comfort level is the body’s effect based on ranges of temperature. 

Range 

Range is defined as the amount or extent a value can be measured. 

Wind Chill 

Wind chill is the felt air temperature on exposed skin due to wind. It 
measures the effect of wind on air temperature. The wind chill 
temperature is usually lower than the air temperature, since the air 
temperature is usually lower than the human body temperature. 

-29.9°C to +59°C with 0.1°C resolution

(-21.8 °F to 138.2 °F with 0.2° resolution)
(“---“displayed if outside this range)

every 1 minute  

1.5m/s - 30 m/s (3.3 mph - 67mph) 

600-1100hPa
-500m-3000m
1 x 3V lithium cell (CR2032)

Approximately 12 months
50 x 18 x 140 mm (2” x 0.7” x 5.5”)

11. Specification

s

Recommended operating temperatures

 :

Temperature checking interval 

:

Wind speed measuring range Barometric

 :

M

easuring range 

:

Altitude measuring range 

:

Power source 

:

Battery life 

:

Dimensions (L x W x H)

  :

12. Troubleshooting Guide

Problem 

Solution 

Wind Chill shows --.- 

The wind chill is meaningless above 50 °F, and is not 
displayed (out of range, or - -.-). 

Impeller appears imbalanced. 

It is normal for the impeller to oscillate as it comes to a 
stop, and it is not imbalanced. The unit contains a very 
small magnet that responds to the earth’s magnetic 
fields. This does not affect the accuracy of the wind 
speed readings and only 

apparent

 when 

slowing

 or

accelerating. 

Vane is noisy at high speed. 

This is normal for the vane to vibrate at high speed. 
Do not operate above 67 mph. 
Above 67 mph, the unit will display ---. 

Display is dim or disappears. 

The LCD display will not operate below approximately 
14 °F. Use the warmth of your body or environment for 
use in cold weather conditions, or Battery is dead. 
Replace the battery. 

1.

T

INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF ELECTRICAL & 

ELECTRONIC EQUIPMENT.

When this product has reached the end of its life it must be treated as Waste Electrical & Electronic 

Equipment (WEEE). Any WEEE marked products must not be mixed with general household waste, 

but kept separate for the treatment, recovery and recycling of the materials used. Contact your local 

authority for details of recycling schemes in your area.

Made in China. 

PO Box 13362 Dublin 2

PR2 9PP

Summary of Contents for D03405









Reviews: