4
TIP REPLACEMENT
•
Replacing the tip should only be done when the iron is switched off and at room
temperature.
•
The tip can be changed or replaced by unscrewing the knurled nut barrel.
•
It is imperative that the iron is switched off, unplugged and allowed to cool before
and after tip replacement.
•
Caution: Damage could occur if the iron is left on without the tip inserted.
•
After removing the tip, blow out any remaining oxide dust that may have formed in
the tip retaining area of the barrel.
Warning
: Care should be taken to avoid getting dust in your eyes.
•
Replace the tip and tighten the knurled nut barrel assembly with your hands.
•
Pliers should only be used to tighten the nut if loosening occurs when the iron is
hot.
•
Do not over tighten the nut as the element could be damaged.
SPECIFICATIONS
CLEANING
•
Cleaning should only be done when the iron is switched off and at room
temperature.
•
The iron may be cleaned with a damp cloth and a small amount of liquid detergent
if necessary.
•
Never submerse the soldering iron in liquid or allow any liquid to enter the case.
•
Do not use any chemicals, abrasives or solvents that could damage the soldering
iron.
I
NFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF ELECTRICAL &
ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical & Electronic
Equipment (WEEE). Any WEEE marked products must not be mixed with general household waste,
but kept separate for the treatment, recovery and recycling of the materials used. Contact your local
authority for details of recycling schemes in your area.
Made in China. PR2 9PP
Man Rev 1.0
Voltage
240V AC 50Hz
Power
48W
