76
HD-8 SERIES V
O P E R A T I N G I N S T R U C T I O N S
PROGRAMMING A REPLACEMENT TRANSMITTER
To program a replacement transmitter, complete the following steps:
1.
Power up the R100E Receiver and verify that the Green Status LED and the Red E-Stop LED are on
steady.
2.
Power up the T100 Transmitter into Programming Mode by Pressing and holding the RED E-Stop button
and then the Green Power Button at the same time. This will power up the T100 into Programming
Mode. The Yellow LED to the right of the GREEN Power Button will begin flashing slowly, (once per
second).
3.
Enter the Programming Password Code by pressing buttons (3, 1, 4, 2) and then press the GREEN Power
button once. The Yellow LED to the right of the GREEN Power Button and the Red LED to the left of
the GREEN Power button will begin flashing rapidly.
4.
Enter the programming values. The programming values for DuraTech are 1266888888.
5.
Press and hold the SETUP button on the R100E Receiver (approx. 5 sec.). The Yellow Setup LED will
start flashing slowly while the R100E Receiver enters into programming mode. Once the Yellow Setup
LED on the R100E Receiver begins to flash rapidly, release the SETUP button. The R100E is now ready
to receive the programming information from the T100 Transmitter.
6.
Press and release the GREEN Power Button on the T100 to start sending the Programming information to
the R100E Receiver. The Green Link LED on the R100E Receiver will begin to flash, and the Green
Status LED on the R100E Receiver will be ON steady. Wait for the Link LED to stop flashing, and for
the Status LED to begin flashing. This signifies that the programming information has been successfully
sent from the T100 Transmitter to the R100E Receiver.
7.
Momentarily Power OFF the R100E Receiver and wait for 5 seconds, then power up the R100E Receiver
again. The new program settings will now take effect.
8.
Press the GREEN Power Button on the T100 Transmitter and observe that the Yellow LED to the right of
the GREEN Power Button of the T100 Transmitter will begin flashing. Also note that the Green Link
LED on the R100E Receiver is flashing and the Green Status LED on the R100E Receiver is on steady.
You are now ready to operate your T100/R100E system.
OUT OF RANGE/LOSS OF SIGNAL
The range of the OMNEX ORIGA is approximately 1,200’. Under certain circumstances, such as low or dead
batteries, loss of signal can occor within that distance. In the event that loss of signal occurs, the transmitter will shut
off, and the engine will be shut off by the engine kill circuit.
