DuraTech Industries HAYBUSTER 147C, Operating Instructions And Parts Reference

Page: 115 / 120

107
1 4 7 C D R I L L S N G K - P A R T S A N D I N S T A L L A T I O N
Note: For a single bottom agitator kit, assemble a bearing spacer plate (#16) between bearing and
second agitator plate (#15).
Step 8. Kit contains 1-1/2” O.D. x 7/8” I.D. washers (#6). Add washers as needed to remove end play from
agitator shaft. See page 96.
Step 9. Bolt existing bearing and sprocket assembly (removed in step #1) to top end of agitator mounting
plate (#29) using (2) existing 3/8” x 1-1/2” aln\csk\ screws (#12). Assemble collar (#8), bracket
(#22), drive shaft stub (#30) and sprocket (#3) as shown. Bolt above assembly to the bottom end of
mounting plate (#29) using (2) 3/8” x 1-1/2” aln\csk\screws (#12). See page 100.
Step 10. Bolt completed assembly (step #9) to end of tank using existing 3/8” x 1-1/2” hex head machine bolt
in top end, 3/8” x 1” (#9) hex head in bottom end. See page 100.
Step 11. Bolt bearing and sprocket assembly (Detail 8400239) with 24 tooth sprocket to upper agitator shaft
using 3/8” x 1-1/2” aln\csk\screw with flat washers, lock washer and hex nuts. See page 100.
Note: Step #11 used only with a dual agitator.
Step 12.
Loosen sprockets and bearings on 1” drive shaft and install drive sprockets. Align all respective
sprockets and secure. See page 100.
Step 13.
Install drive chains (#5 & #6). See page 100.
Step 14. Install wood block idler (#7) using 3/8” x 2-3/4” (#13) hex head machine bolt. Adjust chain tension.
See page 100.
Step 15. Remove existing idler sprocket and spacer and install idler sprocket mount (#28) and existing idler
sprocket using ½” x 1-1/2” hex head machine bolts (#10). Adjust chain tension. See page 100.
Step 16. Repeat steps 1-15 for the second tank.