19
EN
TROUBLE SHOOTING
There is no red glow viewed when pushing the
BAT-CHECK button
• Need to check the polarity of battery to be put in correctly. Then check
either one battery might be very poor or dead.
Seems not too much help even this booster is used
•
Investigate if a current angle might not the same as the camera lens. You
have to test in difference angle for the best result. Of course you need to
prove the batteries are not poor before you try to do further testing.
I could see red glow from my IR camera at night, but the booster did not
work
•
At the first, press the BAT-CHECK to prove your booster is working fine.
Then, check the IR sensor if it is plugged into the IR-IN port. If it was ever
the slave booster before, you need to check if the trigger source option is
resumed to the default for Sensor mode.
I bought two same boosters and both did not work properly:
• Be sure the 1st booster must be remain the default with IR Sensor source
setting, the second booster will be changed for Cable setting.
I noticed some of Slave will be always switched ON even camera did not
work
• Double check for the trigger source option, improper connection in a chain
will cause such problem.
