background image

USP © 2014

DURAGRAIN PRIVACY

GATE KIT ASSEMBLY INSTRUCTIONS

Step 4

 

Uprights Post Metal Support Installation       

(4 Pieces Included)

Uprights

Metal Support

Corner Lip

Corner Lip

Insert one Uprights Post Metal Support 

into one of the Uprights Post End Corner 

(Figure 4a); make sure the corner lip of 

the Uprights Post Metal Support is facing 

towards the Pocket Rail.

Using the 1½" metal sheet screw, drive the Sheet Metal Screw 

(2x) into the 2 pre-drilled holes. (Figure 4b)  The top and bottom 

of the 2 Upright Posts must have the Post Metal Support (4x).

Figure 4b

Step 5

 

Secure Uprights Post and the Pocket Rail with Sheet Metal Screws  

      

Vinyl Screw Cap

(32 pcs included)

1½" Pan Head

Sheet Metal Screw 

(32 pcs included)

Figure 5b

Pre-measure and pre-drilled all 4 corners of Upright Post, on both sides top and bottom, for the Sheet Metal 

Screw (Figure 5a & 5b).  Drive the Sheet Metal Screw into the Upright Post in 4 spots (Figure 5c) then cover 

the Sheet Metal Screw head with the Vinyl Screw Cap. (Figure 5d)

Vinyl Screw Cap

Sheet Metal Screw 

Put a small amount of Vinyl Glue on all  

sides of the Post Cap and gently tap the 

Post Cap into the top of the Uprights 

Post and wipe off any excess Vinyl Glue 

with damp cloth (Figure 6).  Repeat the 

same procedure for the other 2 Upright 

Post Caps.

Top

Uprights

Post

Figure 5d

Figure 6

Completed

DuraGrain Gate Kit

Post Cap

Vinyl Glue

Figure 5a

Figure 5c

Insert

Figure 4a

Summary of Contents for Duragrain Privacy

Page 1: ... abrasive cleaning pad or sponge Vinyl components should be assembled without using excessive force to avoid breakage Assemble gate after fence installation to accurately locate hinge and latch post and proper width size Gates should not be made any wider than 48 to avoid sagging from hinge post All hinge posts properly installed should have steel insert and be filled at least 75 with concrete Cut...

Page 2: ... the Upright Post using 4x Sheet Metal Screw as shown in Figure 2b 2c Completed Upright Posts with the mounted End Channel Figure 2c Pocket Rail Metal Support Step 1 Pocket Rail Metal Support Installation 4 Pieces Included Insert tightly the Metal Pocket Rail support into the empty bottom slot of the Pocket Rails on both end sides of the top and bottom Pocket Rail x4 Figure 1 Figure 1 Metal Pocket...

Page 3: ...e into the picket as shown in Figure 3c Then do the same procedure for the other side Upright Post Figure 3d Figure 3c Upright Post Picket End Channel Pocket Rail Pocket Rail Figure 3d Use a Square Level for all the corners for proper leveling and alignment before doing Step 4 IMPORTANT Slide the remaining Pickets in between the 2 Pocket Rail grooves and the last Upright Post Figure 3e Figure 3e E...

Page 4: ...Rail with Sheet Metal Screws Vinyl Screw Cap 32 pcs included 1 Pan Head Sheet Metal Screw 32 pcs included Figure 5b Pre measure and pre drilled all 4 corners of Upright Post on both sides top and bottom for the Sheet Metal Screw Figure 5a 5b Drive the Sheet Metal Screw into the Upright Post in 4 spots Figure 5c then cover the Sheet Metal Screw head with the Vinyl Screw Cap Figure 5d Vinyl Screw Ca...

Reviews: