- -
2.
Place Ribbon Supply onto the empty Ribbon Supply Spindle and insert the
spindle into the Rear Hub.
3.
Place the Ribbon Rewind Spindle, with the paper core, on the Front Hub.
Note:
Make sure the flanges on the end of the ribbon spindles are on the
right side of the printer when viewing from the front. (
See Figure 2)
4.
Open the Printer Cover using the Printer Cover Release Levers.
(
See Figure 1, pg. 4)
5.
Thread the ribbon down and underneath the Ribbon Mechanism.
Note:
The dull side of the ribbon should face down (face the label stock).
(See Figure 3)
6.
Tape the entire width of the end of the ribbon to the front empty core.
7.
Wind the ribbon onto the take-up core by rotating it with your thumb.
Empty Core
for used ribbon
Put on Front Hub.
Rear Hub
Front Hub
Ribbon Spindle
New Ribbon Supply
Put on Rear Hub.
Flanges on the Ribbon Spindles attaches
to right side of printer.
New Ribbon Supply
Used Ribbon
Front of printer
Back of printer
Dull side of ribbon face down
Vinyl Tape
Ribbon goes
underneath
Print Head
Figure 3
Figure 2
