A.
B.
A.
8. Attach every wing strut to their respective sides (A), both struts are marked ‘L’ and ‘R’ to note left
and right hand sides if looking forward from the cockpit. Secure firmly in place using the
M2.5x8mm screws supplied (B).
Note: For convenience clear tape alone can be used to secure the wing to the fuselage by
running the tape along the entire span of the wing join. However this is not
recommended if you intend to fly the Tundra aggressively.
Note: The propeller should be balanced out of the box, however it is recommended a final
balance check be carried out before attaching to the model. A well balanced prop will
greatly increase all round performance and efficiency of the model in flight.
9. The final stage of assembly is to mount the Durafly 12”x6” carbon propeller using the prop nut as
shown (A). However at this stage it is HIGHLY recommended that all set-up and final checks of
the model be done before finally installing the prop firmly in place.
M2.5x8mm
M2.5x8mm
M2.5x8mm
A.
A.
B.
6
7.
