Durafly Das Ugly Stik, Instruction Manual

Page: 18 / 18

15
Problem Cause Solution
Motor does
not turn
1
.
Battery is not fully charged
.
2 . Transmitter battery low .
3
.
Motors not connected
.
4 . The motor is damaged .
5 . Reciever is not bound to Tx .
6
.
ESC in set
-
up mode
.
Control surfaces
not moving with
stick input
Model does not
fly straight
1
.
Control surfaces not centered
.
2 . CoG is not in the correct position .
Model does not
climb well
1
.
The battery is not fully charged
.
2 . Elevator servo is reversed .
3
.
CG too far backwards
.
Limited Radio
Range
1 . Transmitter / Receiver batteries
are flat.
1. charge/replace batteries.
Model moves
backwards
1 . Turn the props around .
2 . Install a full charged battery .
3
.
Check for connection
between the ESC and
motor
.
4 . Replace motor .
5 . Consult Radio manual and
go through bind procedure
again .
6
.
Hold model and move
throttle to full postion then
back down to idle
.
1. Prop installed backwards
1 . The servo lead is connected
to Rx incorrectly
.
2
.
The servo is damaged
.
1 . Make sure the servo leads
are connect properly
.
2
.
Replace servo
.
1 . Adjust the trims on the
transmitter
.
2 . Re - possition lipo as
suggested
.
1
.
Charge the battery
.
2 . Change servo direction
via Tx .
3
.
Move battery forwards
.
1.Charge the batteries.
TROUBLE SHOOTING: