www.tsicustomerservice.com
A3321
12
OPERATION INSTRUCTIONS
There are 6 brightness levels that can be selected.
Settings F6 - F4 decrease in Amber brightness
Settings F3 - F1 decrease in Spectrafire brightness
FUNCTION
FLAME
The fireplace contains three infrared quartz heating
elements.
The thermostat setting range is 62°F - 82°F (17°C - 27°C) or
continuously ON. To set flame effect so that it works without
heat, press the heater button until the display shows “00”.
The thermostat is adjustable by 2°F or 1°C increments.
The up and down buttons
“ ”
on the remote will increase
/ decrease temperature setting.
To change between
°
F and
°
C press and hold the HEATER
button on the control panel for 3 seconds.
Pressing the timer button will cycle through the timer
settings; 30 minutes, 1 Hour, 2H, 3H, 4H, 5H, 6H, 7H, 8H,
9H and off (00).
HEATER
TIMER
ICON
DESCRIPTION
After the fireplace has ran the fan will continue to run for a
COOL DOWN CYCLE period of time to cool down the
internal parts.
COOL DOWN CYCLE
POWER
The power button supplies power to all of the functions
of the fireplace. The power button will put the insert in a
standby mode. This will turn off all functions at once but
will hold the settings in the memory. By pressing the
Power button again the unit will turn on at the same
settings.
With the power on press and hold the Power button on
the control panel for 10 seconds to disable or re-enable the
heater function. Once disable or re-enabled the emberbed
lights will flash multiple times.
