Duplo DC-616, Service Manual

Page: 159 / 210

157
Chapter 7 6 HELP Mode
7
S2-Y1540
HELP Mode : 50
1. Function
2. Operating Procedure
(1) Slit positions auto adjustment
• Positions of each margin (S1, S2) and center slitter (S3 – S6) are
adjusted automatically.
The entered values on HELP Mode “49” are adjusted automatically.
(1) Slit auto adjustment
• Apply Service JOB: 84 for checking the slit auto adjustment.
1. Set the skew adjusting dial at “0”.
2. Access the HELP Mode “49”, and press the <START> key.
3. Load a check sheet on the feed tray, and press the <TEST> key.
* The test RUN is proceeded by the setting of Service person
JOB84.
4. Measure the processed slit positions.
5. Press the <STOP> key. The HELP mode “49” will exit.
6. Access the HELP Mode “50” and press the <START> key.
7. Press the UP/DOWN cursor key, and input the values of each
fi nished paper width.
H50 Sl.auto adj.
MSL:
XX
.
XX
mm
1:
XX
.
XX
mm
2:
XX
.
XX
mm
MSL:xx.xxmm
1:xx.xxmm
2:xx.xxmm
3:xx.xxmm
4:xx.xxmm
5:xx.xxmm
MSL:xx.xx mm
1:xx.xx mm
2:xx.xx mm
3:xx.xx mm
4:xx.xx mm
5:xx.xx mm
Slit positions
Paper run
direction
-0
8. Press the <SET> key , then DC-616 calculates the magni fi cation
automatically for working out the adjustment values of HELP
Mode “50”. And also the values are input on HELP Mode “49”.