Duplo DC-616, Service Manual

Page: 125 / 210

6
123
Chapter 6 2 Conditions for the Error Detection
S2-Y1540
Slitter 1-6 lock
Within 12 seconds after the slitter driving signal is output, the slitter does not reach the HP or it
does not move from the HP after reaching the HP (detection period: 12 seconds).
Cutter lock
Within 2 seconds after the cutter driving signal is output, the cutter does not reach the HP or it
does not move from the HP after reaching the HP.
Crease lock
Within 2 seconds after the creaser upper blade driving signal is output, the creaser upper
blade does not reach the HP or it does not move from the HP after reaching the HP.
Document in machine
In the standby mode, the PPS2 to PPS4 and margin jam sensor are in the “light blocked” state.
Cover open
The interlock switch is turned off when processing is started or during processing.
Double feed
The ultrasonic sensor exceeds the threshold value.
JOB error
An unsupported job is registered.
USB error
A USB communication error occurs.
Gutter de fl ector
The Gutter sensor is turned on when a job that does not need “Gutter” is registered.
BC error 1
Barcode reading is not successful.
BC error 2
The job printed in the barcode is not registered.
BC error 3
The check digit is not correct.
REG error 1
Particles of dirt adhere to the paper, or the lead mark cannot be read properly.
REG error 2
The REG mark cannot be read (not printed).
REG error 3
The side mark cannot be read properly.
REG error 4
The correction using REG mark causes the slitter to go beyond the limited area.
CCD read error
Both the barcode and REG mark cannot be identi fi ed using CCD while they are turned on.
Document in waste box
The margin jam sensor is in the “light blocked” state for more than the con fi gured period.
-0