Duplo DC-445, Instruction Manual, Page: 22 / 48

19
Before Programming JOB
The DC-445 can save 30 patterns of JOB. This chapter describes how to program a JOB on
the control panel of the DC-445.
Before entering a JOB, accurately measure crease position in mm/inch unit.
Please thoroughly read the description on pages 21 - 23 so that you can create correct JOB.
Programming JOB
The following items should be entered to program a JOB.
JOB number
Select a JOB no. in which the JOB currently being programmed is saved.
JOB name
Put a name to the JOB with Number keys for easy reference.
Paper width
Width of document
Paper length
Length of document
Crease position
Distances between lead edge and each crease position.
The DC-445 can crease up to 15 creases on 1 document.
Air knife (option)
Increases the amount of compressed air to the paper edge when the paper is fed to improve
separating performance.
Suction power
Compressed air is blown out to loosen document. This is to prevent double feed.
Crease depth
This sets the depth of the crease when creasing a document. Set to MAX for heavy paper
and MIN for light paper.
Speed
This is used to select HIGH/LOW processing speed.