L.312.C.M
Mercedes-Benz Sprinter 200/300
Volkswagen Crafter 28-35
15
DUNLOP and the Flying D Device are trademarks of Dunlop International Group and are used under license by DSC Nederland B.V.
www.dunlopsystems.nl
5.7 Spring Alignment
Spring out of alignment—
mounting plate axes
offset
Spring in alignment—
mounting plates parallel
and coaxial
5.8 Maintenance
Following installation, it is recommended that all metal parts are coated
with a protective substance such as body wax.
The system does not require very much maintenance other than…
♦
to maintain air pressure in the springs. Much like a tyre, the system
may lose a little air over time.
♦
to keep the air bellows clean. It is suggested that, when washing
the vehicle, the bellows are inspected and cleaned as necessary
(preferable by spraying). Look in particular for stones or grit
trapped between convolutes, as this may damage the bellow.
CAUTION!
Before fully tightening the bolts that secure the air spring to the
upper and lower brackets, set the vehicle at ride height (spring
height approximately 13.5cm) and ensure that the springs are
correctly aligned.
Summary of Contents for L.312.C.M
Page 17: ......
