Duncan Enviro DD45, Owner'S Manual

Page: 17 / 57

15
Pt. No. 67444
Issue 1019
Transport
1
Raise the drill into the transport position.
2
Important
- To avoid machine damage due to drill
lowering during transport, always close the hydraulic valve
on the drawbar. Move the handle to a position at 90
0
to the
hydraulic line. This applies to the drawbar and disc opener
hydraulic valves where fitted.
3
Locate jack stand in transport position, if fitted.
4
Ensure lighting and oversize warning requirements meet
recommendations published by the local Land Transport
Authority or equivalent.
5
Maximum towing speed 40 km/hr
.
For countries other than New Zealand other speed
restrictions may apply, please refer to your local
transport authority.
Ensure towing vehicle requirements are adequate
for the towed vehicle e.g. mass, brakes. Refer to
recommendations published by the local Land Transport
Authority or equivalent.
Braking when towing can cause the load to jackknife. Use
extra care when towing in adverse conditions such as mud,
inclines and sharp bends.
Lower towing speeds are recommmended on farm roads/
tracks and where one wheel is on or over a road verge.
‘Enviro DD45’
Transport