1) CHANNEL SELECTOR BUTTON:
This push button lets you change channels
manually. The L.E.D.'s show you which channel is "on". If you prefer to use a
footswitch, use the channel selector button to put the amp in the green L.E.D.,
channel first; then the footswitch will operate.
2) INPUT JACK:
This is where you plug in your instrument.
3) FOOTSWITCH:
This jack accepts a standard 1/4" guitar cord and standard
footswitch (not supplied). When hooked up, the footswitch allows you to change
channels and to take advantage of the independent volume and overdrive
controls.
The optional Seymour Duncan footswitch with built-in L.E.D. will glow only when
you’re playing in the red channel.
Some amps produce a loud "pop" through their speakers when channel
switching. The Convertible Amp uses a channel switching circuit built into the
preamp that is isolated from other electronics. No annoying pops will occur when
changing channels.
4) OVERDRIVE, CHANNEL 1 (RED):
This control dictates the amount of preamp
distortion and influences the amount the volume you want to add to your signal.
The lowest setting gives the cleanest signal and lowest volume. The highest
setting gives the most distortion and highest volume.
