Geelseweg, 80 | 2250 | Olen | BELGIUM | Tel. +32 (0) 14 25 92 83 | [email protected] | www.dumor.be
8
When you start the machine the following will happen in sequence:
- The paper pile will lift to the level of the upper sensor finger which stops it moving further up
As the pile is fed in and used up the tray will index upwards about each 15 fed sheets
- The air suction and blast will start up
- The feeding belt will index the top sheet forward about 6 cm
- The gripper rollers will grasp the sheet and move it to the mark reader and under the double sheet controller
- The double sheet controller will check that only 1 sheet is fed in , if not an error message will appear
- If the mark reader is on the slit heads will adjust to compensate for the mark drift
- The heads 1 to 6 will position according to the program requirement
- The machine will check if the gutter deflectors are correctly set for the job , if not it will issue a error message and
they will need to be re-set
- The sheet will advance forwards into the slitters and be slit into several strips
- The strips will advance forwards into the cross cutter and be cut into several cards
- The cards will advance into the cross creasing or perfing tool and be creased or perfed accordingly
- The cards will advance into the strike perf heads and will be intermittently perfed accordingly
- If other linear tools are used they will also re- work the cards
- The cards will be expelled into the outfeed tray or conveyor
ACCURACY OF THE MACHINE
The design accuracy of the machine is +- 0.2 mm cumulative
The machine is only as accurate as the paper that is put in the tray, it will not recuperate for correct poorly cut
paper.
VERY IMPORTANT
The paper has to be :
- Cut straight, or it will skew
- Cut parallel, or it may not feed and will wobble on infeed
- Cut square at least on the front edge, or the first cut will be erratic
- Cut cleanly eg not hooked or rough edges, or the paper may not feed or pull in double sheets
- The paper is not wavy or distorted, or it will feed poorly
- The paper is not curled, or it will not feed correctly
See template C next page
Summary of Contents for Aerocard-Strike
