21
Service Manual for
AHPO / EPO Proofer Oven
CAUTION: Never use any metal tools. Scrapers, files, wire brushes or scouring pads (except for stainless steel
scouring pads) will mar the surface.
CAUTION: Never use steel wool, which will leave
behind particles that rust.
CAUTION: Never use acid-based or chloride-containing
cleaning solutions, which will break down the protective
film.
CAUTION: Never rub in a circular motion.
CAUTION: Never leave any food products or salt
on the surface. Many foods are acidic. Salt contains
chloride.
For routine cleaning, use warm water, mild soap or detergent
and a sponge or soft cloth.
For heavy-duty cleaning, use warm water, a degreaser and
a plastic, stainless steel or Scotch-Brite pad.
Always rinse thoroughly. Always rub gently in the direction
of the steel grain.
Preserving & Restoring
Special stainless steel polishing cleaners can preserve and
restore the protective film.
Preserve the life of stainless steel with a regular application
of a high quality stainless steel polishing cleaner as a final
step to daily cleaning.
If signs of breakdown appear, restore the stainless steel
surface. First, thoroughly clean, rinse and dry the surface.
Then, on a daily basis, apply a high-quality stainless steel
polish according to manufacturer’s instructions.
Heat Tint
Darkened areas, called heat tint, may appear on stainless steel
exposed to excessive heat, which causes the protective film to
thicken. It is unsightly but is not a sign of permanent damage.
To remove heat tint, follow the routine cleaning procedure.
Stubborn heat tint will require heavy-duty cleaning.
To reduce heat tint, limit the exposure of equipment to
excessive heat.
GENERAL CLEANING
The Proofer Water Pan should be cleaned with a mild soap
and warm water solution. After it has been cleaned, remove
all soap residue and thoroughly rinse the pan out with fresh
water. This will prevent soap flavor transfer to the bread.
Clean the inside of the Proofer and Oven compartments
using the tips provided in the STAINLESS STEEL CARE
AND CLEANING section of this manual.
Remove the fan cover at the bottom of the Proofer and wipe
up any excess water that has accumulated in the bottom of
the Proofer.
Open the Proofer door and allow it to air dry for several
minutes. Turn the Proofer heat on for at least 30 minutes to
dry the inside of the oven. Make sure the humidity is turned
off. When the Proofer is dry, turn it off and wait ten minutes.
