Service Manual for
AHPO / EPO Proofer Oven
20
Gasket
is slightly
compressed
Figure 37. Proper Hinge Side Adjustment
4. Adjust the door position by moving the door frame to
seal any gap between the gasket and the oven front near
the hinges. Tighten the hinge screws.
5. Perform the DOOR GASKET COMPRESSION
CHECK.
6. If needed, repeat the above procedure or go to step 7.
Otherwise, replace the Hinge Covers.
7. Perform the Air Wash Door Adjustment – Handle Side
procedure, below. (Do not replace the hinge covers yet.)
Be careful not to over-compress the gasket or
it will cause the door to bind near the hinges.
Air Wash Door Adjustment – Handle Side
1. If open, close and latch the door.
2. Loosen the screws along the outer edge of the Door
Handle.
3. Adjust the door position by moving the door frame to
seal any gap between the gasket and the oven front near
the handle.
4. Tighten the screws.
Gasket
is slightly
compressed
Figure 38. Proper Door Handle
Side Adjustment
5. Perform the DOOR GASKET COMPRESSION
CHECK.
6. If needed, repeat the above procedure or go to the
AIR WASH DOOR ADJUSTMENT – HINGE SIDE
procedure.
7. If the Door Handle Adjustment Slots become exposed,
use Silicone Sealer to seal the openings.
8. Install the Hinge Covers if they were removed.
Be careful not to over-compress the gasket or
it will cause the door to bind near the hinges.
MAINTENANCE
STAINLESS STEEL CARE
Cleaning
Stainless steel contains 70-80% iron, which will rust if not
properly maintained. It also contains 12-30% chromium,
which forms an invisible passive, protective film that shields
against corrosion. If the film remains intact, the stainless
steel will remain intact. However, if the film is damaged, the
stainless steel can break down and rust. To prevent stainless
steel breakdown, follow these steps:
