20
2.6 NETWORK Menu
2. Connection to the network
Remember that incorrect network settings on this
projector may cause trouble on the network. Be sure
to consult with your network administrator before
connecting to an existing access point on your network.
Select “NETWORK” from the main menu to access to
the following functions.
Select an item using the ▲/▼ cursor buttons on the
projector or remote control, and press the ► cursor button on the projector or
remote control, or
ENTER
button on the remote control to execute the item. Then
perform it according to the following table.
• To use the wireless network function of this projector, the designated
USB wireless adapter sold as an option is required. Do not use any extension
cable or device when connecting the adapter to the projector.
• The projector does not allow both wireless and wired LAN to be connected to
the same network.
• Do not set the same network address for both wireless and wired LAN.
• If you do not use SNTP, then you must set the DATE AND TIME during the
initial installation.
• The network function is not available when STANDBY MODE is set to
NETWORK(WOL) or SAVING and the projector is in standby mode. Connect
the projector to the network after setting STANDBY MODE to NORMAL.
(
&
SETUP menu in the Operating Guide)
NOTE
