Duevi EzyDriveCAM, Hardware Installation Manual

Page: 5 / 14

5
Figura 3 – Electronic board of EzyMegaCAM
PL
(connector side)
TO PREVENT
TO PREVENT TO PREVENT
TO PREVENT THE RISK OF ELECTRIC SHOCK, OPEN THE DEVICE COVER ONLY
THE RISK OF ELECTRIC SHOCK, OPEN THE DEVICE COVER ONLY THE RISK OF ELECTRIC SHOCK, OPEN THE DEVICE COVER ONLY
THE RISK OF ELECTRIC SHOCK, OPEN THE DEVICE COVER ONLY
WHEN THE 110 WHEN THE 110 WHEN THE 110 WHEN THE 110 V V V V / 230 / 230 / 230 / 230 V V V V POWER SUPPLY IS SWITCHED OFF POWER SUPPLY IS SWITCHED OFF POWER SUPPLY IS SWITCHED OFF POWER SUPPLY IS SWITCHED OFF....
POWER and DATA
The camera is powered directly by 230 V power line
Data communication from/to the camera is made through power line by HomePlug
®
1.0 system
GND
230 V
BAT
Backup battery
connector
Activity LED
Data transfer
MASTER slot
Lower slot
Use ONLY this one
in case of single SD
card
SLAVE slot
Upper slot
DO NOT use in case
of single SD card
Double SD slot
To install up to
two SD cards
(must be
identical).
Insert/remove
only with device
completely
unpowered
Input/Output
Use provided cable
Link LED
Connection to
HomPlug system
230 V
AC
N = Neutral (blue)
F = Phase (brown)