3.4
Counter Knife and Thread Pull Knife
The clearance of the counter knife 2 to the needle 1 should be 4 mm.
The position of the thread pull knife 3 to the counter knife determines
the knife overlapping and the timing of the cutting.
Caution Risk of Injury !
Turn the main switch off.
Set the thread pull knife and counter knife only with the sewing unit
turned off.
Counter knife
–
Loosen screw 4.
–
Set the clearance.
The clearance between needle and counter knife 2 is 4 mm.
–
Tighten screw 4.
Thread pull knife
–
Turn the handwheel until the thread lever is in its highest position.
–
Loosen screws 5 and 6.
–
Set the position of the thread pull knife 3.
The blades should be overlapped 0.5 mm.
The tip of the thread pull knife should lie centered to the needle.
–
Tighten screws 5 and 6 again.
1
2
4
2
3
5
6
3
28
