6.
Thread trimming
6.1
Trimming pressure between knives
Regulation
The trimming pressure should be as large as possible, however, the
knives should be on touch within the last part of the trimming knife path
only.
–
Tilt the machine, loosen the screw (1), and remove the bolt (2).
–
Set a high pressure between the trimming knives with the screw (3)
so that the resistance against the knife motion is high within the
whole motion path.
–
Gradually reduce the knife pressure with the screw (3) until
compliance with the regulation is achieved.
–
Mount the bolt (2) back again.
30
3
2
1
