16
3.6.3 Side setting of the indented lower pulley
The pulley must be set up in such a way that the belt passes
through the centre of the passing hole in the bedplate. The
setting operation is to be done as follows:
Caution! Danger of injury!
Switch off the main switch! Before starting the
setting operation, wait until the motor stops!
- Loosen the screws (1) of the pulley (2).
- Loosen the screw (3) of the tensioning roller (4)
- Set the pulley (2) in such a way that the belt (5) passes
through the centre of the passing hole in the bedplate (6).
- Tighten the screws (1).
- Set the tensioning roller (4) axially in such a way that the
belt (5) is set at the middle of the tensioning roller (4).
- Set the tensioning roller (see par. 3.6.5).
- Tighten up the screw (3) of the tensioning roller (4).
3.6.4 Side setting of the indented upper pulley
The pulley is to be set in such a way that the indented belt is
not crossed and the pulleys are in line. The setting thereof is
to be done as follows:
Caution! Danger of injury!
Switch off the main switch! Before starting the
setting operation, wait until the motor stops!
- Loosen the screws (1) of the pulley (2).
- Set the pulley (2) in such a way that the distance of 5 mm
is attained in accordance with the illustration.
- Tighten the screws (1).
3.6.5 Setting the tensioning roller
The tensioning roller of the indented belt of the top feeding
is mounted in a rotary way on the bedplate. The belt must be
ten-sioned as needed in such a way that there is ensured the
correct function of the transmission. Insufficient tension can
cause skipping of the teeth, on the contrary, excessive
tensioning enormously loads the mounting of the top shaft.
The setting thereof is to be done as follows:
Caution! Danger of injury!
Switch off the main switch! Before starting the
setting operation, wait until the motor stops!
- Loosen the screw (1) securing the lever of the tensioning
roller (2).
- Tension the belt as needed (theoretically, in applying the
force of 10 N in the middle of the belt with the deflection of
4 mm).
- Tighten the screw (1).
1
2
5
4
3
5
1
2
6
2
1
