![Duerkopp Adler 2180-1 Instructions For Service Manual Download Page 17](http://html.mh-extra.com/html/duerkopp-adler/2180-1/2180-1_instructions-for-service-manual_2538122017.webp)
13
3.6.5 Replacement the indented belt
Before replacing the indented belt, the bottom feeding shaft is to be
removed. The procedure is as follows:
Caution! Danger of injury!
Switch off the main switch! Before starting the setting
operation, wait until the motor stops!
- Loosen the screw (1) of the tensioning roller (2) and loosen it.
- Loosen the screws (3) of the pulley (4).
- Loosen the screws (5) of the feeding clutches (6).
- Loosen the screws (8) of the axial rings (9).
- Loosen the screws (10) of the chain wheel (11).
- Push the shaft (12) to the left in such a way that it is out of the pulley
(4).
- Remove the pulley (4).
- Remove the front guard.
- Loosen and unscrew the screw (14) of the holder of the wheel (15)
and remove it from the holder (21).
- Loosen the screws (16 and 17) of the holder (18).
- Remove the holder (18) together with the holder (15) and articulated
shaft (13) from the machine.
- Loosen the screws (19) of the pulley (20).
-
Loosen the screw of the ring through the hole (24).
- Hold the pulley (20) and pull out the feeding shaft (22) from the arm
in such a way that it is possible to remove the indented belt (23)
from the arm of the machine.
- Replace the belt with a new one and proceed to the assembly (inverted
procedure of dismantling).
- Proceed to the setting operation according to the par. 3.6.2, 3.6.3
and 3.6.4.
11
10
9
4
3
9
8
1
2
21
15
14
24
22
13
17
18
16
23 20
19
12
6
5 6