7
in accordance with the law and current
standards.
Incorrect installation may damage property
or cause harm to people or animals.
Follow below guidelines for built-in
appliance:
• The supporting surface must be
heat-resistant up to a temperature of
approximately 100°C.
• If the appliance is to be installed above
an oven, the oven must have a forced
ventilation cooling system.
• Avoid installing the hob above a
dishwasher: if this cannot be avoided,
place a waterproof separation device
between the two appliances.
Failure to follow this precautions, could
cause a malfunction on the appliance.
POSITIONING
The domestic appliance was built in order
to be encased on a work surface, the
way it is illustrated in the graph (Fig.1).
Predispose sealing material (Fig.4) along
the whole perimeter (for dimensions of the
cut see Fig.1). This operation is necessary
to avoid any liquids penetrating the
worktop, as it is not possible to guarantee
that the top, the glass and their connection
are completely flat.
Lock the domestic appliance into place
with 4 supporters, keeping in mind the
width of the surface (Fig.2).
If the lower part of the appliance after
installation, is accessible via the lower
part of the furniture, it is necessary to
mount a separating panel keeping in mind
the distances indicated (Fig.3).
This is not necessary if underneath the
hob is installed an oven.
ELECTRICAL CONNECTIONS
(Fig.6)
Before making the electrical connections,
check that:
- the ground wire is 2 cm longer than the
other cables;
- the system ratings meet the ratings
indicated on the identification plate fixed
on the lower part of the worktop;
- the system is fitted with efficient ground
wires in accordance with the laws and
current standards.
WARNING! THIS APPLIANCE MUST
BE GROUNDED
The electrical safety of this appliance
can only be guaranteed when continuity
is complete between it and an effective
earthing system, which complies
with current local and national safety
regulations.
It is most important that this basic safety
requirement is present and regularly
tested and, where there is any doubt, the
electrical wiring in the home should be
inspected by a qualified electrician.
The manufacturer cannot be held liable
for the consequences of an inadequate
earthing system such as an electric shock.
The manufacturer cannot be held
liable for damage which is the direct or
indirect result of incorrect installation or
connection.
If the domestic appliance is not supplied
with a cable and/or suitable plug, use
material suitable for the absorption value
indicated on the identification plate and
the operating temperature.
If wishing to make a direct connection to
the mains, an omnipolar switch must be
installed with a minimum 3 mm opening
between the contacts and appropriate
for the load indicated on the plate and in
accordance with current standards (the
yellow/green ground conductor must not
be disconnected by a switch).
When the appliance has been installed,
the omnipolar switch must be easily
reachable.
