28
ENGLISH
L0001779-L
18.09.2018 Installation manual for DucoBox Silent
06.E
Pairing components
Never pair more than one system with RF components at the same time. If you do so, a component in the wrong
network could be paired, e.g. in the neighbours’ DucoBox.
Pairing components on the DucoBox Silent
1
Activate ‘Installer mode’ by tapping ‘INST’ on the DucoBox� The LED
will flash green rapidly�
2
Add control components by tapping once on the component to be
paired� The LED will flash red briefly and then start to flash green
rapidly� Repeat this step until all remaining components in the cur-
rent zone have been paired�
With RF components: start with the component closest to the mas-
ter� If the first pairing is unsuccessful, another component may be
tried first, which can then act as a hop point for components which
are unable to make an RF connection with the DucoBox�
3
Once all components have been paired, ‘Installer mode’ can be
deactivated by tapping ‘INST’ on the DucoBox Silent� LEDs on all
components will stop flashing�
Please refer to the manual with the components for more detailed informa-
tion�
06.F
Removing / replacing components
Paired components can only be removed from the network or replaced within 30 minutes after the component has been paired
or restarted� It can be restarted by powering it down briefly� Remove and replace commands will be ignored after the 30-minute
timeframe� This holds for all components as from production date
170323
�
Removing a component
1
Activate ‘Installer mode’ by
long-pressing 2 diagonal buttons
on a paired control� The LED will
flash green rapidly�
5 sec
2
Press once and hold a button on
the component to be removed
in order to remove it from the
network�
5 sec
3
Deactivate ‘Installer mode’ by
pressing the 4 buttons on a paired
control simultaneously (or using
the palm of your hand on a control
featuring touch buttons)� The LED
will turn white�
Replacing a component
1
Activate ‘Installer mode’ by
long-pressing 2 diagonal buttons
on a paired control� The LED will
flash green rapidly�
5 sec
2
Press briefly twice on the button
of the component to be replaced�
twice
OLD
3
Press briefly once on the button of
the new component� The latter will
take on all settings/links in the
network�
once
NEW
3
Deactivate ‘Installer mode’ by
pressing the 4 buttons on a paired
control simultaneously (or using
the palm of your hand on a control
featuring touch buttons)� The LED
will turn white�
1
2
3
4
5
6
7
8
Example of a pairing sequence
indicates the sequence in which a
component button must be pressed
X
