21
ENGLISH
L2003212 Installation guide for DucoBox Energy Comfort (Plus) (Revision A | 18.10.2022)
Connecting the condensate drain
The unit is supplied with a standard 32 mm drain with a threaded end� Condensate must be drained frost-free and under a slight
slope� The condensate hose must not have any sharp bends�
Iteration
Rev. Date
Name
Description
23-Aug-17
Status Date
Status
MONTAGE_MUUR
mm³
dm²/m
kg/m
mm
Handelsstraat 19 - 8630 VEURNE
tel. 0032-58/330033 - fax.0032-58/330044
email: info @ duco.eu www.duco.eu
This drawing is property of Vero Duco NV and can not be copied, neither shown to
third party/externally without written permission.
0.000
0.000
Drawing Number
Volume
Coat. Surf.
Weight
Outline
MONTAGE_MUUR
Format: A0
Production Number:
Mat.:
Draftsman: -
Tol.: -
Scale: 0.300
-
Date: 23-Aug-17
OR
Iteration
Rev. Date
Name
Description
23-Aug-17
Status Date
Status
MONTAGE_MUUR
mm³
dm²/m
kg/m
mm
Handelsstraat 19 - 8630 VEURNE
tel. 0032-58/330033 - fax.0032-58/330044
email: info @ duco.eu www.duco.eu
This drawing is property of Vero Duco NV and can not be copied, neither shown to
third party/externally without written permission.
0.000
0.000
Drawing Number
Volume
Coat. Surf.
Weight
Outline
MONTAGE_MUUR
Format: A0
Production Number:
Mat.:
Draftsman: -
Tol.: -
Scale: 0.300
-
Date: 23-Aug-17
0000-4376
Standard siphon
(not included in the supply)
When using a standard siphon connection, a water seal
of at least 80 mm must be provided� Before start-up,
it should also be filled with water, to avoid an air leak,
prevent sewer odour in the ventilation system and obtain
a water lock�
Siphon Flat
(not included in the supply)
Preferably use this flat membrane siphon from DUCO, as
it is space-saving and less likely to cause air leaks� It can
be fitted ‘dry’ and it has the advantage that it cannot dry
out in hot weather�
Next steps
After this, you can proceed to the next steps to finish the installation:
• Pairing control components with the DucoBox Energy Comfort (Plus) (Electrical Installation, see page22)�
• DucoBox Energy Comfort (Plus) air-side calibration (see page 25)�
• A timer program can be set if there are no CO
2
and/or humidity sensors fitted in the system (see page 29)�
• Optional: changing settings� The factory settings will suffice in most cases� However, it is possible to configure settings such as
the Bypass and comfort temperature to suit the occupants’ wishes (see page 30)�
After this, the DucoBox Energy Comfort (Plus) is ready for use�
To avoid contamination of the ducts, it is recommended that the unit be operated only when there are occupants, to avoid dust from
the construction phase in the ducts and the unit�
What in case of power failure?
If the power supply to the DucoBox Energy Comfort (Plus) fails, it will retain all its settings� Once power has been restored, the
DucoBox Energy Comfort (Plus) will start up again and run� The correct time will need to be set again if the DucoBox Energy Com-
fort (Plus) is without power for more than (around) 8 hours�
