Casing unit: crankcases
Caution
After installing new main bearings, shim the crankshaft as described under paragraphs
“
"
in this Section.
Reassembling the casings
Carefully inspect the casings. They should be in perfect conditions and clean. Mating surfaces must be perfectly flat
and free from burrs.
Reassembling the clutch-side casing
Check that the following parts are in place inside casing:
Secondary shaft end bearing (15).
Primary shaft bearing (14) secured with screws (
18
) and spacers (
17
).
Main bearing (23).
Roller bearing (21) with circlip (22) at the position of the timing layshaft.
file:///C|/Documents%20and%20Settings/F4i/My...anual/wsm/usa/Mon695_MY07_N_9B9_00.74.1.html (8 of 25) [10/7/2008 8:46:34 PM]