Casing unit: crankcases
Reassembling the generator-side casing
Check that the following parts are in place inside casing:
The double ball ring bearing (10) for the selector fork shaft with plate (
9
) and retaining screws (
8
).
The gearbox primary shaft bearing (12) with inner spacer (
13
).
Main bearing (4).
The ball bearing (7) with circlip (6) at the position of the timing layshaft.
Note
Except for the main bearings, all other bearings do not have a mounting position.
Shimming the shafts
Before closing the casings, calculate the shims required to take up crankshaft and gearbox shafts end float.
To determine correct shimming, proceed as follows.
file:///C|/Documents%20and%20Settings/F4i/My...anual/wsm/usa/Mon695_MY07_N_9B9_00.74.1.html (9 of 25) [10/7/2008 8:46:34 PM]