Casing unit: outer components
Using the special tool, remove head stud bolts (12).
Remove gear selector ratchet and gear stopper as described in Sect. N 7.1,
Removing the gear stopper and ratchet
.
Reassembling the outer components
Check O-ring (
11
) for wear. Change, if necessary.
Fit oil breather valve (10) with O-ring (
11
) inside engine block and tighten to the specified torque (Sect. C 3,
Tighten both plugs (14) and seals (8) to the specified torque (Sect. C 3,
).
Tighten oil filter cartridge support nipple (
17
) to the specified torque (Sect. C 3,
).
Tighten the drain plug (9) with seal (28) to the specified torque (Sect. C 3,
) after applying the
recommended threadlocker.
file:///C|/Documents%20and%20Settings/F4i/My...anual/wsm/usa/Mon695_MY07_N_9A9_00.73.1.html (5 of 10) [10/7/2008 8:46:24 PM]