Ducati DPW 2100, Owner'S Manual

Page: 37 / 44

English
Owner´s manual
DPW 2100
PRESSURE W
ASHER
37
6. When using self suction function, the working
pressure is a little less than general working
situation. If the pressure is much less, please
check if the lance or filter is blocked.
7. If the lance is not high-low type, self suction
is applicable normally but it’ll take more time
for water to come out (about 30s-50s).
NOTE:
In operation, the screen in filter should be
cleaned some time especially if water condition
is not good.
12. SELF-SUCTION FUNCTION´S USE
Please read the instruction carefully for your
using this appliance.
1. Suitable environment: surrounding tempe-
rature <45°C and introduction of non-co-
rrosive liquid with temperature <60X1 and
viscosity<100cP(like city water supply, well
water, rain water, etc).
2. Being different from general pressure water,
self-suction high pressure washer gets an
important function. This function permits the
pressure washer absorb water from water
tank or well( 1 m of suction) automatically.
3. Working environment: in case of city water
supply, the pressure washer can work by
connecting to the city water supply; in case
of no city water supply, water tank, water
case or well could used as water sources.
4. Suction: (height of absorbing water >1M,
less than 1,5M is recommended).
5.
Time needed: when pressure washer
applies self suction, it’ll take time <30S;
Lance must be at low pressure position (see
P11)
In case of no water out after it works more
than 60S, must stop the machine and check
if following conditions exists:
1) Height of absorbing water is too big, must
be less than 1,5M;
2) Water inlet hose is not in the water or on
the surface of water.
3) Filter is blocked.
4) Lance is at high pressure position.