Ducati Diavel Carbon ABS, Owner'S Manual

Page: 93 / 203

92
E
Immobilizer override procedure
This procedure makes it possible to “temporarily“ turn on
the motorcycle if the HF (Hands Free) System is not working.
Note
The PIN CODE function must be activated by entering
your 4 digit PIN in the dashboard, otherwise the vehicle
cannot be turned on temporarily in the case of a malfunction.
Warning
The motorcycle owner must activate (store) the PIN
code; if there is already a stored PIN, contact an Authorised
Ducati dealer to have the function “reset“. To perform this
procedure, the Authorised Ducati Dealer may ask you to
demonstrate that you are the owner of the motorcycle.
PIN CODE activation function
To access the function it is necessary to view the “setting”
menu page 48, using button (1, fig. 14) “ ▲ ” or (2, fig. 14)
“ ▼ ” select the “PIN CODE” function and press the reset
button (12, fig. 12) to go to next page.
Note
If “MODIFY PIN CODE“ appears when accessing this
function, this means that there is already a stored PIN and
therefore the function is already active.
When accessing the function, “INSERT NEW PIN CODE”
with four dashes “- - - -“ in the bottom line will appear on the
display highlighted in green; now enter a 4 digit code.
Entering the code:
press the reset button (12, fig. 12).
each time you press the button (2, fig. 14) “ ▼ ” the displayed
number increases from “0” to “9” and then returns to “0”;
to confirm the number, press the reset button (12, fig. 12).
Repeat the procedure until inserting the fourth digit.
To highlight the “MEMORY” indication, press the reset
button (12, fig. 12) again.
To store the entered PIN, press the reset button (12, fig. 12)
for 3 seconds with “MEMORY” indication highlighted in
green.
As a confirmation of PIN storage, the display will show the
message “MEMORIZED” for about 2 seconds and then
automatically highlight “EXIT” option.
From this moment, “MODIFY PIN CODE” will be displayed
when accessing the “PIN CODE” function and the PIN can
be changed again as many times as necessary (without
limits).
To exit the setting function, press the reset button (12, fig.
12) when “EXIT” is highlighted.